Fitted to end of trunking for attachment of electrical conduit. P2521 for use with P1000 and P2000 Channels. Countersunk head screw and clamping nut included.
Fittings - General Information
Material
Unless otherwise noted, all fittings are punch press formed from plate or strip steel.
Fitting Application
All product drawings illustrate only one application of each fitting. In most cases many other applications are possible. The members shown in the illustrations are P1000, 41mm square, except where noted otherwise. All 14mm diameter holes use M12 x 24 hex head set screws and M12 nuts - P1010, P4010 or P5510 - depending on the channel used. Nuts and bolts are not included with the fitting and must be ordered seperately
Design Load Data
Design load data, where shown, is based on the ultimate strength of the connection with a safety factor of 2.5.
Finishes
All fittings in this section are available in zinc plated finish to Australian Standard AS1789 and Hot Dipped Galvanised to AS/NS4680.
General Data
| Part No. | P2521 |
| Finish | Zinc Plated |
| Description |
Conduit End Connector
|
| Size mm | 22mm |
| Box/Bndl Qty | |
| Mass kg/100 | 12 kg |
The following dimensions apply to all fittings except as noted on
the individual part drawings:
- Hole Size - 14mm diameter
- Hole Spacing - 21mm from end
- Hole Spacing - 48mm on centre
- Width - 40mm
- Thickness - 6mm
Order this product by phone
We ship Australia wide 
Quality Products
30 days free return