Cantilever Bracket P2516A Hot Dipped Galvanised 700mm

P2516A

Call 02 9150 7744 For the BEST DEAL

  Part No. Finish Size Mass kg/100 Description DesignUniform Load kN P2516A Hot Dipped Galvanised 700mm 216 CANTILEVER BRACKET 0.62 Material Unless otherwise noted, all fittings are punch press formed...

 

Part No. Finish Size Mass
kg/100
Description DesignUniform
Load kN
P2516A
Hot Dipped Galvanised 700mm 216 CANTILEVER BRACKET 0.62

Material
Unless otherwise noted, all fittings are punch press formed from plate or strip steel.

Fitting Application
All product drawings illustrate only one application of each fitting. In most cases many other applications are possible. The members shown in the illustrations are P1000, 41mm square, except where noted otherwise. All 14mm diameter holes use M12 x 24 hex head set screws and M12 nuts - P1010, P4010 or P5510 - depending on the channel used. Nuts and bolts are not included with the fitting and must be ordered separately.

Design Load Data
Loadings are as shown based on calculations in accordance with AS/NZS 4600 and AS 4100.

Design Bolt Torque
Refer to Engineering Data (See Page 118).
 

Finishes
All fittings in this section are Hot Dipped Galvanised to AS/NZS4680 unless otherwise shown.

Standard Dimensions
The following dimensions apply to all fittings except as noted on the individual part drawings:

Hole Size - 14mm diameter
Hole Spacing - 21mm from end
Hole Spacing - 48mm on centre
Width - 40mm
Thickness - 6mm

 

**For further product information please see attachment Catalogue.

Catalogue (Unistrut_Brackets.pdf, 272 Kb) [Download]

Data Sheet (Unistrut_Engineering_Data.pdf, 468 Kb) [Download]

Good to know