90 Degrees Angle Plate Fittings P1325 Zinc Plated Chromate

P1325ZA

Call 02 9150 7744 For the BEST DEAL

Fittings - General Information Material Unless otherwise noted, all fittings are punch press formed from plate or strip steel.   Fitting Application All product drawings illustrate only one application of each fitting. In most cases many other applications are possible. The...

Fittings - General Information

Material
Unless otherwise noted, all fittings are punch press formed from plate or strip steel.
 

Fitting Application
All product drawings illustrate only one application of each fitting. In most cases many other applications are possible. The members shown in the illustrations are P1000, 41mm square, except where noted otherwise. All 14mm diameter holes use M12 x 24 hex head set screws and M12 nuts - P1010, P4010 or P5510 - depending on the channel used. Nuts and bolts are not included with the fitting and must be ordered seperately

Design Load Data
Design load data, where shown, is based on the ultimate strength of the connection with a safety factor of 2.5.

Finishes
All fittings in this section are available in zinc plated finish to Australian Standard AS1789 and Hot Dipped Galvanised to AS/NS4680.

General Data

Part No. P1325
Finish Zinc Plated Chromate
Description
 90 Degrees FITTING
Hole Size
14mmDiameter
Hole Spacing
21mm from end
48mm on centre
Width 40mm
Thickness 6mm
Box/Bndl Qty

 

Mass kg/100 33 kg

General Data applies to Flat Plate, 90 Degree, ANgular, "Z", "U" & Wing Shape Fittings

 

**For further product information please see attachment Catalogue.

Catalogue (Unistrut_Fittings.pdf, 2,012 Kb) [Download]

Data Sheet (Unistrut_Engineering_Data.pdf, 468 Kb) [Download]

Good to know